Plastic drainage ditch
The main material of Plastic surface drainage ditch is HDPE (High-Density Polyethylene). They are primarily used for collecting surface water and directing rainwater into municipal drainage networks. These channels feature high strength, corrosion resistance, aging resistance, easy installation, cost-effectiveness, and eco-friendly recyclability, making them highly popular in European, American, and Australian markets. They are widely applied in urban streets, residential squares, parking lots, parks, ports, airports, green landscapes, building platforms, and other fields.
Advantages:
Lightweight and easy to install
Corrosion-resistant
Recyclable
High strength
Fast drainage
With built-in locking mechanism
 |
 |
 |
| Plastic drainage ditch + stainless steel cover plate | Plastic drainage ditch + stainless steel cover plate | Plastic drainage ditch + plastic cover plate |
|
100 Series |
 |
150 Series |
 |
|
Inner width × inner height × length 100×45×1000 mm 100×100×1000 mm 100×150×1000 mm |
Inner width × inner height × length 150×150×1000 mm |
||
|
200 Series |
 |
250 Series |
 |
|
Inner width × inner height × length 200×200×1000 mm 200×250×1000 mm 200×250×500 mm |
Inner width × inner height × length 250×250×1000 mm |
||
|
300 Series |
 |
400 500 Series |
 |
|
Inner width × inner height × length 300×300×500 mm 300×300×1000 mm |
Inner width × inner height × length 400×400×1000 mm 500×500×1000 mm |
The first step is to determine the size of the trench excavation
The second step is the concrete structure
When the concrete structure of section H reaches the required height and the load-bearing grade reaches E600-F900, 8mm steel bars should be used to make 15cm x 15cm grid structure reinforcing bars for section H. In this step, it is necessary to design an appropriate inclination for the water inlet on both sides of the drainage ditch.
The third step is the layout of the trench body
Starting from the installation of the water outlet, fix the bottom first to facilitate the pouring of the concrete on the side. For Part S, select the appropriate size according to the requirements of the design drawing. The completed surface of the drainage ditch is recommended to be 3 to 5mm lower than the completed surfaces of both sides of the ground, and the maximum height must not exceed the height of the completed surface of the ground. Pre-install the selected cover plate to prevent deformation of the trench body due to pressure from the concrete structure. As in the second step, the concrete structure on the side also needs to be reinforced (reinforcement bars are required for those with a load-bearing grade of E600 and above).
The fourth step is to decorate the surface (such as floor tiles, etc.
If a decorative surface needs to be laid, it must be 3 to 5mm higher than the horizontal plane of the trench.
Address: Building B2, No. 188, Hailuo Road, Quanjiao County, Chuzhou City, Anhui Province，China
yajing
Messages
